- Be able to recognise S5 hardware and be able to replace modules when a fault occurs.
- Be able to operate the Step-5 software to make it perform certain tasks.
- Understand basic S5 instruction set and be able to make minor modifications to software.
- Be able to backup and restore a PLC program when required.
- Be able to perform basic system diagnostics when a problem occurs.
To fault find a system you need to know EXACTLY how it works
Am I getting the input to the PLC?
The Led on the output card means i am getting voltage out right? does it?
What exactly happens in between? ,theres more than just a program in the CPU
How exactly does it scan the program?
What is this Watchdog Timer? Is it that important?
Can I use the same output twice? That’s bad programming isn’t it?
A PLC is a logic controller, so use a logical approach to fault find it.
What are the 8 simple test points to check?
The PLC is in RUN, that means theres a program right? does it?
FORCING a bit and toggling a bit is pretty much the same yeah? depends on which PLC
Then you need to Know the specifics
- How do I check power is ON and PLC is in right mode (RUN or Program)
- Check for a fault condition
- Establish a link to the PLC (project settings)
- If comms problem check PG/PC interface
- Create a blank project and take a backup (just in case I mess up)
- Open project for PLC and go OnLine
- Interrogate I Stack and B stack
- Identify if it is a hardware or software fault?
- Change the battery
- Change modules if necessary, (with spares and without spares)
- Identify if it is a PLC or Comms fault
- Check all settings against a template etc.
- Check Hardware
- Clear Memory and Download program
- Check software against latest copy (Compare function)
- Monitor program
- Searching for specific operands and instructions
- Changing timer, counter values On Line
- Making minor mods Off Line and On line
- Check or create a status table to establish parameter status
- Force a parameter if required
- Use Xreference to assist with software diagnostics
- Upload and Download project
- Display Documentation (Symbols, Comments)
- Reassign an I/O address and change software addresses (Rewire Function)
- Printing Cross Reference / Program Listings etc.
Background information also covered
Understanding of the following:
Introduction to MS-DOS
- Siemens DOS Files (ST.S5D, PX.INI) etc
- Number formats, bits, bytes, words, double words
- Binary, HEX,octal,floating point, integer
- Data types and parameter types, Bool etc.
- I/O Addressing
- Block types
- Variable types (local and global)
- How to monitor various blocks (OB, PB, FB, DB etc.) (FBs in particular)
- Ladder, STL, FBD programs
- Basic Instructions, contacts, Set, reset etc.
- Timers, Counters
- Comparators, Maths
- How to make minor mods
- Altering values in a status variable table
- Back tracking through a program to establish where power flow stops
- Overall reset procedure
- Fault finding tips
- Training Log
- Pre Course Exercises
- Course Exercises
- Post Course Exercises
- Filofax Pocket Reference Guides
Course Equipment (per delegate)
- S5 PLC
- PC or Laptop
Interesting and Informative
Course: Siemens S7 300/400 PLC Level 1
In 16 years at name withheld this was by far the most interesting and informative course I have been on.
- Jarno Barratt (June 28, 2019)
Submit a review for Siemens S5 100/115 PLC Level 1
Fill out the form below to submit a review we would love to know your opinion.
All the fields with a * are required fields.